How to Read a Miami-Dade NOA
A Notice of Acceptance is the approval that makes a window legal to install at your address. Here is what is on it and what to check before you sign.
What an NOA is
A Miami-Dade Notice of Acceptance is the county's approval for a specific window or door assembly, issued after the product has been tested for impact, pressure and water resistance. Miami-Dade's criteria are the strictest in the country, which is why an NOA is accepted by many Broward jurisdictions in place of separate local testing.
The document is tied to a manufacturer and a product line, not to a house. It lists the configurations, sizes, design pressures and installation methods the product is approved for. Anything outside those limits is not covered, even if it is the same product family.
The four things to check
First, the product line and manufacturer, which should match the proposal exactly. Second, the design pressure, which has to meet or exceed what your address requires for that opening. Third, the size limits, because a window approved at one size is not automatically approved at a larger one. Fourth, the installation method and anchor schedule, since the approval covers how the unit is fastened into the wall, not just the unit itself.
There is also an expiration date. NOAs are reissued periodically, and a proposal quoting an expired approval is a permit problem waiting to happen. The number on your proposal should be current and should correspond to the product being ordered.
Why it matters east of the Intracoastal
Broward County sits inside Florida's High Velocity Hurricane Zone, and within the county the requirement changes with exposure. Properties east of the Intracoastal are in the wind-borne debris region, where the design pressure and the debris impact requirement are higher than they are further inland.
In practice that means the same window can be acceptable on one side of the Intracoastal and not on the other. We confirm the requirement for the address before the proposal is written, so the product on the paper is the product that will pass inspection.
What to ask your contractor
Ask for the NOA or Florida Product Approval number for each opening on the proposal, and ask which design pressure it is approved for. A contractor who can answer that at the estimate has already done the engineering work that the city will check later.
Ask what happens if the inspector finds the anchor detail does not match. The answer should be that the detail comes from the approval, so there is nothing to reconcile at final.
Related service
Impact French Doors in Fort Lauderdale & Broward CountyHinged impact French doors for formal entries and lanai openings, with sidelights and transoms where the wall allows, approved for your wind zone.
Common questions
Is an NOA the same as a Florida Product Approval?
They are two approval routes with the same purpose. A Miami-Dade NOA is issued by Miami-Dade County; a Florida Product Approval is issued by the state. Many Broward jurisdictions accept either, and each proposal lists the number that applies to that product.
Does my proposal need the NOA attached?
It should list the approval number for every opening, and the full document goes in with the permit application. If a proposal has no approval numbers, it is not ready to compare.
What if my opening is larger than the approved size?
Then the product needs a different configuration, a different panel count, or a different product line that is approved at that size. We check the size against the approval before the order is placed.
Free estimate in Broward County
Measured on site, itemized by opening, with the product approval for every unit.
